SAFETY FUNCTIONS
FUSE CHECK/REPLACEMENT
EMERGENCY PUSH-BUTTON
DRIVER'S SEAT MICROSWITCH
ANTI-SKID SAFETY SYSTEM
MACHINE ANGLE SENSOR
HOPPER POSITION SENSOR
HOPPER SAFETY VALVE
ENGLISH
36
NOTE
All of the machine's electronic circuits are protected by electronic devices which reset automatically. The safety fuses
blow only in the event of serious faults.
Refer to the service manual available from Advance retailers.
The machine is equipped with the following safety functions.
It is to the left side of the operator (69). It has to be pressed in case of emergency, to stop all the machine functions.
This is located inside the driver's seat (3) and it does not allow the machine to operate if the operator is not seated on the driver's
seat.
Reduces speed to a safe value, where necessary, when steering and when driving on a camber, in order to prevent skidding and
increase the machine's stability in all operating conditions.
If the hopper is to be raised with the machine not on level ground, the system reduces the speed of movement of the hopper and
When the hopper is lifted, the safety valve on the hydraulic lifting cylinder prevents the hopper to accidentally lower.
For this reason, fuses should only be replaced by qualified personnel.
warns the operator that the machine stability conditions may be critical depending on the weight of refuse contained, via a different
buzzer sound and the icon on the display (71) as shown in figure 28.
When the hopper is lifted, the sensor reduces the machine speed, turns off the vacuum fan and stops the broom rotation.
INSTRUCTIONS FOR USE
SW5500 - 1467287000
Figure 28
P100918
09/2016