Safety Information - Hach NT3100sc Manual Del Usuario

Specification
Sensor pressure limit
Ambient temperature
Sample temperature
Dimensions (Ø x L)
Weight
Altitude
Pollution degree
Overvoltage category
Environmental conditions Outdoor use
Sensor materials
Strut materials
Process connection
Certifications
Warranty
Section 2 General information
In no event will the manufacturer be liable for damages resulting from any improper use of product or
failure to comply with the instructions in the manual. The manufacturer reserves the right to make
changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.

2.1 Safety information

The manufacturer is not responsible for any damages due to misapplication or misuse of this product
including, without limitation, direct, incidental and consequential damages, and disclaims such
damages to the full extent permitted under applicable law. The user is soley responsible to identify
critical application risks and install appropriate mechanisms to protect processes during a possible
equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
4 English
Details
0.5 bar
2 °C to 40 °C (36 °F to 100 °F), 95% relative humidity, non-condensing
2 °C to 40 °C (36 °F to 100 °F), 95% relative humidity, non-condensing
70 × 402 mm (3 × 15.8 inches) approximately
4.4 kg (9.70 lb) with 10 m cable
2000 m (6562 ft) maximum
2
II
Enclosure: Stainless steel
Enclosure seals: Silicone
Wiper axle, arm (5 mm) and wiper blade carrier (1 mm and 2 mm): Stainless steel
Wiper blade: Silicone
Measuring window: Quartz glass
Sensor cable: Polyurethane (PUR)
Cable gland: Stainless steel
Seal cable gland: PVDF
Struts: Stainless steel
Filtration sensor adaptor: Stainless steel
Immersion directly in media
Bypass (for 2 mm and 5 mm path)
Sedimenter
CE, CMIM and UKCA approved
1 year (EU: 2 years)