DeLonghi ELETTA EXPLORE ECAM45.5Y Serie Instrucciones De Uso página 29

PROBLEM
The brewing unit (A6) cannot be
extracted.
At the end of descaling, the appliance
requests a third rinse.
Milk does not flow from the milk spout
(E5) or (F5).
The milk contains large bubbles and
squirts out of the milk spout (E5) or (F5)
there is little froth.
The cup shelf (A13) is hot.
After cleaning, you can't put the drip tray
back in the machine
The machine emits noises or small puffs
of steam while not in use
The appliance emits puffs of steam from
the drip tray (A15) and/or there is water
on the surface the appliance rests on.
The To Go beverage is too much or has
spilled out of the travel mug
POSSIBLE CAUSE
The appliance has not been turned off
correctly
During the two rinse cycles, the water
tank (A20) has not been filled to the MAX
level
The milk carafe lid (E1) or (F1) is dirty
The lid (E1) or (F1) is not assembled
correctly.
The milk is not cold enough or not suita-
ble for the beverage requested
The milk carafe lid (E1) or (F1) is dirty
There is water in the groove under the
froth adjustment dial (E3) or (F3)
Plant-based beverages have been used.
A number of beverages have been pre-
pared in rapid succession
The condensate tray(A12) is not in the
correct position
The machine is ready for use, or has re-
cently been turned off, and condensate is
dripping into the hot vaporiser
The drip tray grille (A14)has not been put
back after cleaning.
An unsuitable quantity has been selected Choose a smaller quantity (Medium
L
29
SOLUTION
Turn the appliance off by pressing the
button (A9) (see section "6. Turning the
appliance off").
Follow the instructions displayed by the ap-
pliance, but first empty the drip tray (A15) to
avoid the water overflowing.
Clean the milk carafe lid as described in
section "16.9 Cleaning the milk carafes
(E) and (F)".
Assemble all the components correctly as
described in sections "10.1 Preparing the
milk carafes (E and F)" and "10.4 Adjust-
ing the amount of froth".
For best results, make sure to use the
right type of milk to prepare hot or cold
beverages (see section "10.2 Which milk
to use?"). Use beverages at refrigerator
temperature (about 5° C).
Clean the milk carafe as described in sec-
tion "10.6 Cleaning the milk carafe after
use"
Extract the dial and dry thoroughly.
For best results, use beverages at refriger-
ator temperature (about 5° C). Adjust the
amount of froth as described in section
"10.4 Adjusting the amount of froth"
This is part of normal operation.
Make sure the condensate tray is inserted
correctly
This is part of normal operation. To limit
the phenomenon, empty the drip tray.
Put the drip tray grille back in the drip
tray.
L
or Small )
S
Adjust the quantity in the mug so that
the next beverage is prepared correctly
→