Adjusting The Amount Of Froth; Making Milk Beverages; Cleaning The Milk Carafe After Use - DeLonghi ELETTA EXPLORE ECAM45.5Y Serie Instrucciones De Uso

2. Fill the milk carafe (E2) or (F2) with a sufficient quantity
of milk, not exceeding the MAX level marked on the carafe
(fig. 19);
3. Make sure the milk intake tube (E6) or (F6) is correctly in-
serted on the bottom of the milk carafe lid (fig. 20);
20
4. Put the lid back on the milk carafe;
5. Attach the carafe to the connector (A8) and push as far as it
will go (fig. 21). The machine emits a beep (if the function
is enabled);
6. Place a sufficiently large cup under the coffee spouts (A7)
and milk spout (E5) or (F5). Only the milk spout (E5) can be
lengthened by adjusting the extension;
7. Select the beverage you want to make as described in the
following paragraphs.
Please note:
If "Energy Saving" mode is enabled (see section "7.9 General"),
you may have to wait a few seconds before the appliance makes
the beverage.

10.4 Adjusting the amount of froth

Turn the froth adjustment dial (E3) or (F3) to adjust the amount
of froth on the milk delivered while making milk beverages.
Dial
position
Hot
• Latte
• Hot milk (not
MIN
frothed)
froth
• Latte Macchiato
• Flat White
MED
• Cortado
froth
• Cappuccino
• Cappuccino Mix
MAX
• Espresso
froth
Macchiato
• Cappuccino +
• Hot milk
(frothed)
Recommended for...
Cold
• Latte
• Latte Macchiato
• Flat White
• Cappuccino
• Cappuccino Mix
• Cold milk (frothed)

10.5 Making milk beverages

On the homepage (C), press the image corresponding to the
beverage you want to make (C1).
As for coffee beverages, you can make a customized beverage
by pressing the
on the homepage.

10.6 Cleaning the milk carafe after use

Each time you deliver a milk beverage, the appliance asks you to
perform the CLEAN function to clean the milk carafe lid (E1) or
(F1). To start cleaning, proceed as follows:
1. Leave the milk carafe in the machine (you do not need to
empty it);
2. Place a cup or other recipient under the milk spout (E5) or
(F5) (fig. 22);
21
3. Turn the froth adjustment/clean dial (E3) or (F3) to "Clean"
(fig. 23). Hot water and steam are delivered from the milk
spout. Cleaning stops automatically;
4. Turn the dial back to one of the froth selections;
If you want to make a number of beverages in succession:
• To proceed with making the next beverages, when the
"Clean" message is displayed, press "Cancel". Clean the milk
carafe after making the last beverage.
At the end of preparation, the milk carafe is empty, or
there is not enough milk for other recipes
• After cleaning using the "Clean" function, extract the milk
carafe and clean all the components as described in section
"16.9 Cleaning the milk carafes (E) and (F)"
At the end of preparation, there is enough milk left in
the carafe for other recipes
• After cleaning using the "Clean" function, extract the milk
carafe and place it immediately in the refrigerator. The
"HOT"
more than 2 days and the "COOL"
than 1 day, then all the components should be cleaned as
described in section "16.9 Cleaning the milk carafes (E) and
(F)".
15
(C2) symbol at the bottom of the image
22
carafe can be kept in the refrigerator for no
Clean
23
carafe for no more