Clamping Jaws - Stanley EZM1000 Manual De Instrucciones Y Servicio

O R I G I N A L I N S T R U C T I O N

6.2 CLAMPING JAWS

Remove the front sleeve, see 6.1.
Remove the clamping sleeve (A) and the Tefl on ring (B), the 2
clamping jaws (C) and the jaw pusher (D).
Clean the clamping jaws and the jaw pusher or replace them.
Make sure that the spanner does not slip off
the locking nut (E). This may damage the
hydraulic piston rod (F).
Mounting is done in reverse order.
When mounting, lightly spray the inside of
the clamping sleeve with Tefl on spray.
Make sure that the locking nut is positioned
between 19-20 mm from the hydraulic body.
E N G L I S H
13