Operation - cecotec BOLERO DRESSCODE 6000 Manual De Instrucciones

Connection between an ordinary tap and the water supply hose.
Fig. 8.
1. Loosen the clamp nut and four bolts.
2. Tighten the clamp nut.
3. Press and slide the hub and insert the water supply hose in the connection base.
4. Connection finished.
Connection between a screw tap and the water supply hose. Fig. 9.
- Screw tap and water supply hose.
- Special tap for washing machine.
Connect the other end of the water supply hose to the inlet valve in the rear part of the product
and fasten the pipe tightly clockwise. Fig. 10.
Drain hose
Note:
Do not kink or protract the drain hose.
Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
1. In a drain pipe. It is recommended to use a vertical tube.
2. In a sink's drain pipe, over the trap. Fig. 11.
If the washing machine has a drain hose bracket (depending on the model), it can also be
installed on a sink or a tank, as indicated next. Fig. 12.
Warning
When installing the drain hose, fix it properly with a rope or a clamp. If the drain hose is too
long, do not force it into the washing machine as it will cause abnormal noises.

4. OPERATION

Warning
- Please make sure the appliance is properly installed before operating it.
- Before washing the clothes for the first time, the product shall be operated in a complete
washing cycle without the clothes inside.
QuickStart
Before washing
1. Plug the device into a power supply.
ENGLISH
DRESSCODE 6000/7000/8000
57