Operation - cecotec Bolero Serie Manual De Instrucciones

Loosen the clamp nut and four bolts.
Tighten the clamp nut.
Press slide bushing and insert inlet hose into connecting base.
Connection finished.
Connection between screw tap and inlet hose. Fig. 9.
Tap with threads and inlet hose.
Special tap for washing machine.
Connect the other end of inlet hose to the inlet valve at the backside of product and fasten the
pipe tightly clockwise. Fig. 10.
Drain hose
Note: Do not kink or protract the drain hose.
Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
In a drainpipe. It is recommended to use a vertical tube.
In a sink's drainpipe, over the trap.
Fig. 11.
If the machine has drain hose support, it can also be installed on a sink or a tank, like the
following. Fig. 12.
Warning: When installing drain hose, fix it properly with a rope. If drain hose is too long, do not
force it into washing machine as it will cause abnormal noises.

4. OPERATION

Note:
Please make sure the appliance is properly installed before operating it.
Run one whole cycle while the appliance is empty before using it for the first time.
Calibration
It is recommended to calibrate the appliance. To do so:
Empty the washing machine.
Plug it in.
Turn the appliance on and press Speed and Delay at the same time within 10 seconds. The
display will show "t19".
Press the Start/Pause button for the appliance to start washing. The display will show "****".
BOLERO DRESSCODE_8600 INVERTER / 9600 INVERTER / 9600 INVERTER STEEL / 12600 INVERTER
02326_02330_02331_02338_Bolero DressCode_8600 Inverter / 9600 Inverter / 9600 Inverter Steel / 12600 Inverter_YV_02210311.indd 57 02326_02330_02331_02338_Bolero DressCode_8600 Inverter / 9600 Inverter / 9600 Inverter Steel / 12600 Inverter_YV_02210311.indd 57
ENGLISH
57
11/3/21 16:55 11/3/21 16:55