Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after
use.
2. Clean the battery and battery charger with
a dry cloth. Keep the battery guide tracks
clean.
3. Make sure that the terminals on the battery
and the battery charger are clean before
the battery is put in the battery charger or
the product.
To lubricate the shaft
Lubricate the ends of the drive shaft after
each 30 hours of operation. There is a risk
that the ends of the drive shaft (splined
coupling) wears if they are not lubricated
regularly.
1. Disassemble the shaft. Refer to
disassemble the shaft on page 15 .
2. Lubricate the end of the drive shaft.
3. Assemble the shaft. Refer to
the shaft on page 14 .
To apply dielectric grease to the
shaft coupling
Apply dielectric grease to the inner surface of
the shaft coupling and the outer surface of the
shaft after each 30 hours of operation.
1. Disassemble the shaft. Refer to
disassemble the shaft on page 15 .
22
2. Apply dielectric grease to the inner surface
3. Assemble the shaft. Refer to
To check the chain drive sprocket
1. Regularly check the degree of wear on
To
To examine the cutting equipment
1. Make sure that there are no cracks in
To assemble
2. Make sure that the saw chain is easy to
To
3. Compare the saw chain with a new saw
of the shaft coupling and the outer surface
of the shaft.
the shaft on page 14 .
the drive sprocket. Replace if wear is
excessive.
rivets and links and that no rivets are
loose. Replace if it is necessary.
bend. Replace the saw chain if it is rigid.
chain to examine if the rivets and links are
worn.
To assemble
1744 - 008 -
Publicidad
Tabla de contenido
Solución de problemas
