To Assemble The Branch Hook; To Disassemble The Shaft; To Attach The Harness Support Hook; To Adjust The Harness - Husqvarna MADSAW 525iDEPS Powerhead Manual De Usuario

5. Tighten the knob fully.

To disassemble the shaft

1. Turn the knob 3 turns or more to loosen
the coupling.
2. Push and hold the release button.
3. Hold tight to the end of the shaft segments
that you are to remove.
4. Pull the shaft straight out of the coupling.
1824 - 004 -

To assemble the branch hook

• Use 2 screws to attach the branch hook.

To attach the harness support hook

• Attach the harness support hook on the
product with the spacer, the bolt, the nut
and the knob.

To adjust the harness

Always use the harness when you operate the
product. The harness gives maximum control
during operation of the product. The harness
decreases the risk of tiredness in your arms
and back.
1. Put on the harness.
2. Attach the product to the harness support
hook.
3. Adjust the length of the harness until the
support hook is roughly level with your
right hip.
15