Makita VC009G Manual De Instrucciones página 9

Stand-by switch
The stand-by switch is the switch to turn on/off the
wireless activation function. The vacuum cleaner is in
the stand-by state regardless of the switch position and
it runs when button is pushed.
Fig.8
► 1. Stand-by switch
Switch position
AUTO I The vacuum cleaner is in the stand-by state and
(ON) the wireless activation function is available.
O The vacuum cleaner is in the stand-by
(OFF) state however the wireless activation
function is not available.
Switch action
Fig.9
► 1. Suction power change button 2. ON/OFF button
To start the cleaner, simply push the ON/OFF button. To
switch off, push the ON/OFF button again.
You can change the suction power of the cleaner in three
steps by pushing the suction power change button. Each
push on this button repeats the 1 to 3 mode in a cycle.
Level
1
2
3
1
Status
1
2
Indication Mode
Normal speed
mode
High speed mode
Max speed mode
NOTE: You can change the suction power before
turning on the cleaner.
NOTE: The cleaner starts the operation with the
same suction power as the last operation.
NOTE: If you remove the battery immediately after
turning off the appliance, while the motor is rotating,
the cleaner may not start the operation with the same
suction power as the last operation.
Hose band
Hose band can be used for holding the hose or free
nozzle.
To secure the hose to the vacuum cleaner body, pass
the hose band through the slot on the body. You can
attach the hose band on either side.
1
Fig.10
► 1. Hose band 2. Slot 3. Hose
The loop on the lower belt can be used for carrying
nozzles as illustrated.
2
1
Fig.11
► 1. Loop 2. Nozzles
ASSEMBLY
CAUTION:
Always be sure that the appli-
ance is switched off and the battery cartridge
is removed before carrying out any work on the
appliance.
9 ENGLISH
2 3
1
2