ELICA KIT0179549 Guía De Instalación, Uso Y Mantenimiento página 10

13 Replace the 6 screws previously retired and place the
additional 10 - 4.2 x 8 mm screws contained on the
hardware bag to the back cover of the shell.
For models ELN136S2, ELN142S2, ELN148SS, ELI136S2 and
ELI142S2
1 Remove the 4 - 6.5 x 3.5 mm top plate screws and the top
shell plate.
2 Fix support bracket and spring tab, support brackets to the
appropriate screw slots following the next image.
10
A. Top plate
B. 4 screws
A
B
B
D
A
A. Support bracket
B. Spring tab
C. 3 - 4.2 x 8 mm screws
D. 2 - 4.2 x 8 mm screws
3 Slide halfway the mounting plate of the blower motor
assembly, from the side of the shell, gently over the
support bracket and the spring tab inside the shell with the
wiring connection pointing to the front.
C
4 Push the right end of the motor mounting plate up and
snap it into the spring tab.
NOTE: The spring tab should be outside the slot in the
mounting plate.
B
C
A
A. Mounting plate
B
B. Spring tab
C. Wiring connection
D. Support bracket
D
A
B
A. Motor mounting plate
B. Spring clip