ELICA KIT0179549 Guía De Instalación, Uso Y Mantenimiento página 9

7 Slide halfway the mounting plate of the blower motor
assembly, from the front of the shell, gently over the
support bracket and the spring tab inside the shell with the
wiring connection pointing to the front.
A. Mounting plate
B. Spring tab
C. Wiring connection
8 Push the right end of the motor mounting plate up and
snap it into the spring tab.
NOTE: The spring tab should be outside the slot in the
mounting plate.
9 Place nuts over the top of the shell on the right slots.
C
A
B
A
A. Nuts
A
10 Align mounting holes in motor mounting plate with motor
mounting clip nuts and install 5 - 6 x 16 mm screws with
clip nuts.
C
B
A
A. Screw with lock washer
B. Mounting hole in motor mounting plate
C. Clip nut
11 Attach power cord connector from the range hood to
connector on wiring box.
A
B
A. Wiring box connector
B. Power supply connector from range hood
12 Replace side covers with the previously removed screws
and with 6 - 4.2 x 8 mm screws from the hardware bag for
each cover and tighten.
9