Publicidad
Step 10
Separate the EXTENSION SLIDES (4) from the EXTENSION RAILS (3) as
å
shown in the enlarged diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (3) to the LARGE EXTENSION BLOCKS (L).
å
Use four BLACK 1/2" FLAT HEAD SCREWS (19).
NOTE: For each EXTENSION RAIL, turn a SCREW into the back hole. Then,
å
slide the inner cartridge of the EXTENSION RAIL in to fi nd the other hole that
lines up with the hole in the LARGE EXTENSION BLOCK. Turn a SCREW into
this hole.
NOTE: The EXTENSION SLIDES will be used later for the LARGE DRAWER.
å
BLACK 1/2" FLAT HEAD SCREW
(4 used in this step)
Back hole
G
Page 14
3
Push up on the black lever and pull the SLIDE from the RAIL.
19
3
C
Back hole
L
Open end
A
www.sauder.com
4
3
Use these holes.
3
L
Open end
Open end
423912
Publicidad
