General Operation - Steamfast SF-294 Guia Del Usuario

GENERAL OPERATION

NOTE: Be sure that Water Tank has been  lled and all
desired accessories are connected before following
these steps.
1. For  rst-time use, remove protective plastic cover that is
shipped on electrical plug. Plug power cord into a
convenient electrical outlet.
2. Turn Steam Control Dial clockwise from "OFF" position to
desired steam setting (FIGURE 9). Power Indicator Light
will immediately illuminate to indicate that unit is powered
on and heating.
NOTE: Steam settings are broken down by intensity
("LOW" & "HIGH") as well as function ("MOP/FABRIC"
& "HANDHELD CLEANER"). Refer to Page 13 for more
information about selecting steam settings.
3. After approximately 30 seconds, you will hear a buzzing
sound as unit begins to emit steam.
4. Direct Steam Nozzle (with any connected accessories)
towards surface you wish to steam. Refer to Steam
Mopping section below, as well as Fabric Steaming and
Steam Cleaning sections on Page 12, for further details.
CAUTION: Always be sure that Steam Nozzle and any
accessories are pointed in a safe direction (away from
yourself, other people, pets and plants) when steaming.
STEAM MOPPING
NOTE: It is recommended to sweep or vacuum  oors before mopping.
•
Make sure Extension Pole, Mop Head and a Micro ber Pad are all properly connected. Refer to Pages
6 & 7 for details.
•
Follow General operating instructions above to begin steaming. For best results, set unit within
"MOP/FABRIC" range as indicated on Steam Control Dial.
NOTE: Only "LOW" setting is recommended for hardwood  oors.
•
Mop using a steady back-and-forth motion over the  oor, working your way backwards in order to avoid
walking over the freshly mopped area.
NOTE: To avoid warping or damage caused by heat and moisture, do not use on unsealed hardwood
or unglazed ceramic surfaces. Steam may remove the sheen from some  oors that have been
treated with wax.
•
The Micro ber Pad will absorb moisture during mopping. However, depending on  oor surface and steam
intensity setting, some residual moisture may be left behind. In this case, it is recommended to allow  oor
time to air-dry. A fan may be directed towards mopped area to facilitate drying.
•
Due to large size of the Mop Head, it may have dif culty completely cleaning certain types of  oors (such as
ceramic tile) that include crevices of grouting. To more thoroughly clean  oor grout, it is recommended to
use 3-in-1 Steam Mop in steam cleaning mode. Refer to Steam Cleaning section on Page 12 for details.
FIGURE 9
ENGLISH | 11