Microfiber Pads - Steamfast SF-294 Guia Del Usuario

MOP HEAD
CAUTION: Always allow unit to cool before connecting/disconnecting any accessories.
1. Align Mop Head with main unit as shown (FIGURE 2), so that neck is in line with Steam Nozzle.
2. Slide Mop Head neck into Steam Nozzle, pressing  rmly until release button snaps through hole.
3. To remove Mop Head, press  rmly on release button while simultaneously pulling Mop Head
away from Steam Nozzle.

MICROFIBER PADS

1. Lay one Micro ber Pad on  at surface, with two fastener strips facing upward.
2. Align Mop Head above Micro ber Pad. Make sure Mop Head is oriented with Pad as shown,
and centered as best as possible (FIGURE 3-A).
3. Press Mop Head  rmly down onto Micro ber Pad. Fastener strips will adhere to pad grips on
underside of Mop Head. Pad should now be attached and ready for use (FIGURE 3-B).
CAUTION: Use care when handling a recently used Micro ber Pad, as it may still be hot.
NOTE: Micro ber Pads are machine washable. To avoid picking up lint, washing
separately from other fabrics is recommended. Only use liquid detergent. Avoid using
any fabric softeners or bleach. Air drying is recommended; machine drying on a low
setting is acceptable as well.
MOP
HEAD STEAM
NECK NOZZLE
RELEASE
BUTTON
HOLE
FIGURE 2
A B
FIGURE 3
ENGLISH | 7