Steamfast SF-294 Guia Del Usuario página 16

PROBLEM
Unit fails to heat up. Power
Indicator Light DOES NOT
illuminate.
Unit heats up, but fails to steam.
Power Indicator Light does
illuminate.
(NOTE: Always allow proper
time for unit to heat up and
begin producing steam.)
Steam output is weak or
intermittent.
Excess water in steam  ow.
Rattling sound is heard coming
from Water Tank.
Floor surfaces appear cloudy or
streaky after steaming.
Steam coming through Pressure
Relief Valve on back of unit.
16 | ENGLISH
Troubleshooting
POSSIBLE CAUSE
Unit is not plugged in.
Steam Control Dial is set to "OFF"
position.
Household circuit breaker / ground
fault interrupter has tripped or
blown a fuse.
Unit is damaged or otherwise in
need of repair.
Water Tank is empty.
Mineral build-up in unit.
Weighted brass ball connected to
end of water tube inside Water
Tank has come loose.
Steam Control Dial is set to
"LOW".
Mineral build-up in unit.
Steam Control Dial is set to
"HIGH".
Sound is being caused by
weighted brass ball connected to
end of water tube inside Tank.
Micro ber Pad is dirty.
Hard water residue on  oor.
Mineral build-up in unit.
SOLUTION
Plug power cord into electrical
outlet.
Turn Dial clockwise to desired
steam intensity setting.
Reset circuit breaker / ground
fault interrupter, or replace fuse.
If you need assistance, contact a
licensed electrician.
Immediately cease usage and
unplug. Contact Consumer
Service for further assistance (see
Page 17 for details).
Refer to Filling Water Tank
procedure on Page 10.
Refer to Mineral Build-up section
on Page 15 for cleaning procedure.
If brass ball has become
disconnected from tube, simply
reattach it by snapping it back
onto black nozzle at end of tube.
Increasing the Dial setting will
result in a stronger (and wetter)
 ow of steam. Refer to Pages
11-13 for more information.
Refer to Mineral Build-up section
on Page 15 for cleaning procedure.
At "HIGH" setting, some amount
of water may be released along
with the steam. Decreasing the
Dial setting will reduce this water
spotting.
The weighted brass ball is an
intentional design that helps the
unit more ef ciently utilize all
water inside of Water Tank.
If brass ball has become
disconnected simply insert it back
into end of tube.
Replace Micro ber Pad with a
clean one.
Switch to distilled or
de-mineralized water.
Refer to Mineral Build-up section
on Page 15 for cleaning procedure.