Status Leds - DJI T40 Guía De Usuario

Status LEDs

1
2
3
Status LED Blinking Pattern
Solid yellow
Blink green once continuously
Charging Channel
Solid green
Status LED
Blink yellow once continuously
Blink red once continuously
Blink yellow four times continuously
DC Module Status
Blink yellow once continuously
LED
Blink red once continuously
Blink yellow four times continuously
Generator (excl. DC
Blink yellow once continuously
Module)/AC Module
Blink red once continuously
Status LED
Blink red four times continuously
• When the status LEDs blink for warning or error, connect the charger to the remote controller using a
USB-C cable to see more information.
• If any part of the charger is abnormal or damaged, it is recommended to contact a DJI-authorized
dealer or DJI Support to repair or replace the part.
Activation
The intelligent charger must be activated before using for the first time. Connect the remote controller to the
internet first. Use a USB-C cable to connect to the USB-C connector of the charger and the USB-A connector of
the remote controller. Run the DJI Agras app on the remote controller and tap
main interface to enter the charging device interface to activate the charger.
4
4
USB-C Connector on the
Intelligent Charger
1. Charging Channel Status LED
2. DC Module Status LED
3. Generator (excl. DC Module)/AC Module Status LED
4. USB-C Connector Cover
Description
The charger is ready to connect to a battery
Charging
Fully charged
Warning for the battery/charging channel
Battery/charging channel error
DC module is not activated
Warning for the DC module
DC module error
Generator (excl. DC Module)/AC module is not activated
Warning for the generator (excl. DC Module)/AC module
Generator (excl. DC Module)/AC module error
Generator (excl. DC Module) maintenance is required
USB-C Cable
USB-A Connector on the
Remote Controller
on the upper left corner of the