Updating Firmware; Storage And Maintenance - DJI T40 Guía De Usuario

Updating Firmware

There will be notifications when firmware updates are available on the DJI website. Pay attention to the Download
page of the product on the DJI website to get the latest firmware. Follow the instructions below to update the
firmware of the charger using the remote controller.
1. Connect the remote controller to the internet and then connect the charger to the remote controller using a
USB-C cable.
2. Run the DJI Agras app on the remote controller and update the firmware by following the instructions.

Storage and Maintenance

Storage
When you are not using the charger, disconnect the charger from AC power and disconnect the charging cable
from the battery. Place the charger in a stable place.
• DO NOT place the charger under direct sunlight or in rain or other wet environments.
• Keep the charger away from heat, pressure, water, flammable gases, and corrosives.
Maintenance
Clean the dustproof cover regularly to ensure the heat dissipation performance.
1. Remove the four screws and remove the dustproof cover.
2. Clean the dustproof cover and install it back in place. Install the four screws to secure the dustproof cover.
Specifications
Item T40 Intelligent Charger
Model Number CSX602-9500
Operating
-5° to 40° C (23° to 104° F)
Temperature
Output Channel 1
Input: 3 Phase 380-420 VAC, 50/60 Hz, 16 A MAX
Output: 59.92 VDC, 150 A MAX
Input/Output
Input: 1 Phase 220-240 VAC, 50/60 Hz, 16 A MAX
Output: 59.92 VDC, 50 A MAX
Compatible
T40/T30/T20P Intelligent Flight Battery
Battery
Dimensions 400×266×120 mm
Weight Approx. 12.7 kg
T20P Intelligent Charger
CSX602-4500
-5° to 40° C (23° to 104° F)
1
Input: 3 Phase 380-420 VAC, 50/60 Hz, 16 A MAX
Output: 59.92 VDC, 70 A MAX
Input: 1 Phase 220-240 VAC, 50/60 Hz, 16 A MAX
Output: 59.92 VDC, 46 A MAX
T40/T30/T20P Intelligent Flight Battery
318.5×254×108 mm
Approx. 8.8 kg
7