DJI T40 Guía De Usuario página 6

Using the Intelligent Charger
Connecting to Three-Phase AC Power
• Strictly follow the steps described below in order.
• Besides other electrical devices, make sure that the electrical distribution box can provide at least 12
kW of power (at least 16 A of current) for the T40 Intelligent Charger and at least 6 kW of power (at
least 16 A of current) for the T20P Intelligent Charger. If you need to connect the charger to a third-
party three-phase generator, make sure that the output power of the three-phase generator also meets
the corresponding requirements.
1. Turn off the air circuit breaker for the three-phase AC power supply.
2. Rotate and open the cover of the three-phase AC power cable (power supply) and connect the two three-
phase AC power cables. Connect the three-phase AC power Cable (charger) to the AC power port of the
charger.
1
3. Connect the intelligent charger to the three-phase AC power supply:
Connect the three conductors (labeled L1, L2, L3) of the three-phase AC power cable (power supply) to the
three hot terminals of the air circuit breaker and the one ground wire (labeled PE) to a grounding terminal of the
electrical distribution box.
• Only qualified electricians can wire the charger to three-phase AC power and they must wear insulating
gloves.
• DO NOT connect the ground wire to a neutral terminal or hot terminal.
Power Input
Electrical Load
Hot Wire
Ground Wire
L1 L2 L3
Hot Wire
L1 L2 L3
2
PE
Ground Wire
PE
5