Inspection And Maintenance Plan - Gude MK 18-0 Traducción Del Manual Original

ENGLISH ENGLISH

Inspection and maintenance plan

Generally
Before any start-up
After every take out of
service
Storage
Failures
Failures
The saw does not work
Not sufficient output
Follow-up brake
36
Complete saw
Plastic body
Saw Chain
Chain saw bar
Chain saw wheel
Chain Brake
Saw Chain
Chain saw bar
Chain lubrication
Chain Brake
Follow-up brake
On/off Button
Chain saw bar
Bar fixture
Saw Chain / Chain saw bar
Complete saw
Tracing
Electric motor does not run
or stops.
Low dilatability
Saw chain runs out
Regularly clean the outer part
Let regularly checked by authorized workshop
Check for cracks and fissures
Let regularly sharpen
Clean regularly
Clean regularly
Regular functional test
Check for damages and sharpness
Check the chain tension
Oil after approx. five sawing operations.
Functional test
Functional test
Functional test
Clean above all guiding oil groove
Dismount, clean and lubricate slightly by oil Clean the
saw guiding groove
Causes
Voltage missing
Battery is defective
Battery compartment
defective
Activated power breaker
Worn out coal brushes
Worn out coal brushes
Removal
Reinsert battery Insert new
battery
Have the battery shaft repla-
ced by a specialist workshop
or Güde Service.
Check supply line, consult
specialist workshop.
Have the carbon brushes
replaced by a specialist
workshop.
Have the carbon brushes
replaced by a specialist
workshop.