Adjusting For Fastener Length - Senco DURASPIN DS530 Serie Manual Del Usuario

INSTAllING THE DS530-D1 OR DS530-D2 ADAPTER AND ATTACHMENT
1. To prepare the screw gun before installing the screw-on adapter.
a. Unplug tool from electrical supply or remove battery before installing attachment.
b. Remove the nose cone.
c. Remove manufacturer's bit and holder if present.
d. Unscrew the stock DeWalt clutch housing by rotating clockwise (threads are left-hand/reversed). The
use of a wrench may be necessary.
e. Remove the output shaft assembly from the stock clutch housing and reinstall into the supplied Senco
adapter.
f. Thread adapter onto the DeWalt tool by rotating counterclockwise.
g. Torque adapter onto tool to 50 in. lbs. with an adjustable wrench.
2. Install the bit and the attachment onto the tool as described in steps 6-7 in the previous section.
ADJUSTING FASTENER lENGTH
1. Unplug tool from electrical supply or remove battery before adjusting nose-piece for fastener length.
2. Depress the screw selector pin until it is flush with nosepiece and slide the nosepiece to the desired
setting by aligning hatch marks with the silver adjustment pin.
3. Release pin ensuring it is fully engaged in selected nosepiece slot for proper operation.
Nosepiece has these possible settings:
1" 1 1/4"
DeWalt Tool
1 1/2" 1 5/8"
TOOl USE
Output Shaft Adapter
Assembly
DS530
1 3/4" 2"
8
2 1/4" 2 1/2" 2 3/4" 3"