Loading The Tool; Driving Screws - Senco DURASPIN DS530 Serie Manual Del Usuario

lOADING THE TOOl

CAUTION
beware of sharp points on screws. Avoid grabbing this area during loading and
operation.
1
4. Feed the strip into the slide body until the first screw is aligned with the bit. The tool will feed all
subsequent screws automatically as the tool is pulled back off the work surface, returning to its
relaxed state.
5. To remove the strip, pull it through from the top of the nosepiece.
ADJUSTING DEPTH OF DRIVE
1. This tool is equipped with a locking depth-control adjustment.
2. Depress the lock switch to release the thumbwheel and rotate it to a notched position. Adjust the
amount of countersink by turning the thumbwheel clockwise to go more shallow, or counter-clock-
wise to go deeper. Release the lock button after adjustment, and make sure the thumbwheel is
locked into a notched position.
3. Test drive screws while adjusting until the desired countersink is reached.

DRIVING SCREWS

1. Whenever possible, hold the tool at a right angle (perpendicular) to the work surface.
2. Pull the trigger to start the motor.
3. Press the nosepiece with constant force against the work surface. Do not remove the tool from the
work surface until the clutch disengages and the bit stops rotating, signalling a fully driven screw.
4. Continue to allow the motor to run. The next screw will be automatically fed into place when the tool
is pulled off the work surface.
TOOl USE
1. Make sure the heads of the screws are resting on top of the plastic colla-
tion material.
This will ensure proper strip advancement and prevent jamming.
2. Check for proper fastener length setting (see "Adjusting for Fastener
length" above).
3. Feed the strip into the strip guide up toward the nose of the tool.
9