Connection For Jack Plug (A); Power In Connection (J); Measurement Shunt Connection (I) - Abicor Binzel EWR 2 Manual De Instrucciones Original

EWR 2/EWR 2 Net
Tab. 2
Pos. Name
(E)
(L)

4.3.1 Connection for jack plug (A)

The connection for the jack plug (3.5 mm, 3-pin) forms the RS232 test, configuration and diagnostic
interface for the device. The connection can be used to connect to a computer with installed
ABICOR BINZEL service software.
NOTICE
Restricted functionality due to contamination
If dirt or dust gets into the connection for the jack plug, it is possible that the jack plug is not inserted
correctly and the operation of the device may be restricted.
► Close the cover of the connection for the jack plug when no jack plug is inserted.
Tab. 3

4.3.2 Power IN connection (J)

(M12 circular plug, 4-pin, A-coded)
Tab. 4

4.3.3 Measurement shunt connection (I)

(M8 circular plug, 4-pin, A-coded)
Tab. 5
Control elements
Function
<OK> button Use this button to select a menu item and confirm an entry.
Display The display shows target and actual values, parameters, and error
conditions. The display's background lighting switches off automatically
after 5 minutes. The background lighting can be regulated manually as of
firmware version A.01.03.00.
 8.7 Submenu 4 Settings on page EN-20
Connection for jack plug
Segment
Top
Middle
Rear
Power IN connection
PIN
1
2
3
4
Measurement shunt connection
PIN
1
2
3
4
4 Product description
Name
Rx (as seen by device)
Tx (as seen by device)
GND
Name
For service only
24 V
For service only
GND
Name
+V
−V
GND
Analog signal ±4 V
EN - 11