EWR 2/EWR 2 Net
8.5 Submenu 2 Authorization
4.2 Authorization levels/password on page EN-9
If the password entered is incorrect, the authorization level is set to <User>. In the "User" authorization level,
only reading of the target values is possible; it is not possible to make configurations. The password for the
"Setter" authorization level can be changed by the "Setter/Service" via the software service.
8.6 Submenu 3 Logbook
Active errors are shown immediately on the display. The ten most recent error messages are displayed in the
Logbook submenu. The previous error messages are not saved and are discarded. The time and date refer
only to operating times during which the device has or had power.
To open the submenu, press the <OK> button.
1
The display for entering the password appears.
To select the required settings/values, press the <◄ ►> and <▲▼> arrow
2
buttons.
To save the setting and go to the previously selected submenu item, press the
3
<OK> button.
Subsequently, <Password wrong> appears if the entry is incorrect, and
a corresponding authorization level appears if the entry is correct.
To return to the main menu, press the <▲> arrow button or the <On/Bypass>
4
button.
To open the submenus, press the <OK> button.
1
Error number/error type are displayed.
To switch between the error messages, press the <▲▼> arrow buttons.
2
To display the time the error occurred, press the <◄ ►> arrow buttons.
3
To return to the fault number/fault type, press the <OK> button.
4
To save the setting and go to the previously selected submenu item, press
5
the <OK> button.
To return to the main menu, press the <▲> arrow button or the <On/Bypass>
6
button.
8 Operation
EN - 19