Commands/Parameter - Canopen - Abicor Binzel EWR 2 Manual De Instrucciones Original

14 Description of interface
Tab. 12 Commands/parameters – serial and Ethernet
Command r/w Authorization Reply
fmax x
L/s I-all
s-Setter
foffs x L/s I-all
s-Setter
outp x r/w l-all
s-Setter
EWR 2 Net
copid x
r/w l-all
s-Setter
copbd x r/w l-all
s-Setter
Ip w x y z r/w
l-all
s-Setter
nmask r/w l-all
w x y z s-Setter
Gateway r/w l-all
w x y z s-Setter
dhcpip x r/w l-all
s-Setter
tcpto x r/w l-all
s-Setter
Error messages
14.2 Commands/parameter – CANopen
Address r/w Description
0x1002 r Status register
0x2108sub1 r Temperature
0x2109sub1 r Input voltage
0x6400sub1
r Operating mode
0x6401sub1
r Incoming pressure
0x6402sub1 r Outgoing pressure
0x6403sub1 r Flow
0x6404sub1 r Shunt current
0x6200sub1 r/w Basic flow
0x6200sub2 r/w Stagnation pressure
EN - 26
Description
fmax x Basic flow
x = basic flow in I/min
foffs x Flow offset at maximum x = offset flow in Nl/min
outp x Outlet stagnation pressure
x = pressure in 1/10 bar
copid x CANopen Node ID
x = CANopen Node ID
x = 0 ≙ 125 kBit/s
copbd x CANopen baud rate (speed)
x = 1 ≙ 250 kBit/s
x = 2 ≙ 500 kBit/s
x = 3 ≙ 1000 kBit/s
Ip w x y z IP address for TCP server.
A restart is required to adopt the IP.
nmask w x y z Netmask for TCP server.
A restart is required to adopt the IP.
Gateway w x y z Gateway for TCP server
A restart is required to adopt the IP.
dhcpip x Change-over switch DHCP/static IP.
x = 1 DHCP
x = 0 static IP
tcpto x Setting the TCP timeout. If no communication occurs
during this time, the TCP connection is disconnected.
Establishing connection again is required.
x = 0 off, no timeout
x = 1 to 10,000 timeout in ms
err 1 Unknown command
err 2 Number of arguments incorrect/authorization does
not exist.
err 3 Value range of arguments infringement.
Unit/explanation
Coded as Ethernet command "sys"
1/10 degrees Celsius
1/10 volts
0: Bypass, 1: Outlet pressure regulation, 2: volume flow regulation
1/10 bar
1/10 bar
1/10 l/min
% (of connected shunt value)
1/10 l/min
1/10 bar
EWR 2/EWR 2 Net
Value range
x = 2 to 23
x = 0 to 7
x = 2 to 20
x = 0 to 255
x = 0 to 3
w = 0 to 255
x = 0 to 255
y = 0 to 255
z = 0 to 255
w = 0 to 255
x = 0 to 255
y = 0 to 255
z = 0 to 255
w = 0 to 255
x = 0 to 255
y = 0 to 255
z = 0 to 255
x = 0 or 1
x = 0 to 10,000