Sauder 427287 Manual De Instrucciones página 13

Step 7
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (35MA) to the LEFT END (B) and LEFT UPRIGHT (D).
Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other hole
that lines up with the hole in the END and UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the LARGE DRAWERS.
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
Open end
www.sauder.com/service
35MC
3S
B
3
2
1
35MA
D
427287
1
2
3
7
Open end
Page 13