Sauder 427287 Manual De Instrucciones página 33

Step 27
å
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S)
into the remaining BACK (G) until the shoulders of the
SCREWS rest on the surface of the BACK.
å
NOTE: Do not overtighten the SCREWS.
å
Slide a BACK MOLDING (U) onto the BACK (G). Line
up the grooves in the MOLDING over the heads of the
SCREWS in the BACK.
å
NOTE: The MOLDING should be centered on the BACK.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
www.sauder.com/service
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
G
Shoulder
427287
32S
U
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the BACK.
Page 33