Sauder 427287 Manual De Instrucciones página 48

Step 42
1
D20
Groove
å
Insert the SMALL DRAWER SIDES (D20 and D21)
at an angle into the slot at each end of the SMALL
DRAWER FRONT (M).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the SMALL DRAWER BACK (D74) to the SMALL DRAWER SIDES (D20 and D21).
Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the groove of the SMALL
DRAWER BACK (D74).
å
Repeat this step for the other SMALL DRAWER.
Page 48
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D21
M
D74
D20
D716
2
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D716) into the grooves in
the SMALL DRAWER SIDES (D20 and D21) and SMALL
DRAWER FRONT (M).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D21
427287
U n fi
n i s h
s u r
e d
f a c
e
D716
D20
D21
M
30S
(8 used in this step)
www.sauder.com/service
9
With the palm of
your hand, tap
the DRAWER
BOTTOM down
into the groove.