Sauder 427287 Manual De Instrucciones página 6

Step 1
å
Assemble your unit on a carpeted floor or on the empty carton to avoid
scratching your unit or the floor.
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the LEFT END (B) and
LEFT UPRIGHT (D) until the shoulders of the SCREWS rest on the surfaces of
the END and UPRIGHT.
å
NOTE: Do not overtighten the SCREWS.
å
Slide two SIDE MOLDINGS (S) onto the LEFT END (B) and LEFT UPRIGHT (D).
Line up the grooves in the MOLDINGS over the heads of the SCREWS in the
END and UPRIGHT.
å
NOTE: The MOLDINGS should be centered on the END and UPRIGHT.
å
NOTE: If the MOLDING comes up off of the SCREWS,
remove it and slide it on again.
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
Page 6
Look for this icon. It means a video assembly tip is
available at www.sauder.com/service/tips
Find the numbered video or scan the QR code.
32S
B
D
S
Shoulder
427287
0
S
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the END and UPRIGHT.
www.sauder.com/service