Sauder 427287 Manual De Instrucciones página 24

Step 18
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the RIGHT
END (A) and RIGHT UPRIGHT (C) until the shoulders of the SCREWS
rest on the surfaces of the END and UPRIGHT.
å
NOTE: Do not overtighten the SCREWS.
å
Slide two SIDE MOLDINGS (S) onto the RIGHT END (A) and RIGHT
UPRIGHT (C). Line up the grooves in the MOLDINGS over the heads of
the SCREWS in the END and UPRIGHT.
å
NOTE: The MOLDINGS should be centered on the END and UPRIGHT.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and
slide it on again.
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
Page 24
32S
C
A
S
Shoulder
427287
S
Apply pressure with your hands as you
guide the MOLDINGS over the SCREWS
and onto the END and UPRIGHT.
www.sauder.com/service