Sauder 427287 Manual De Instrucciones página 46

Step 40
1
D24
L
Groove
å
Insert the DRAWER SIDES (D24 and D25) at an angle
into the slot at each end of the DRAWER FRONT (L).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the DRAWER BACK (D109) to the DRAWER SIDES (D24 and D25).
Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the groove of
the DRAWER BACK (D109).
å
Repeat this step for the other DRAWER.
Page 46
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D25
D109
D24
D716
2
D24
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D716) into the
grooves in the DRAWER SIDES (D24 and D25) and
DRAWER FRONT (L).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D25
427287
With the palm of
your hand, tap
the DRAWER
U n fi
BOTTOM down
n i s h
s u r
into the groove.
e d
f a c
e
D716
D25
L
30S
(8 used in this step)
www.sauder.com/service
9