Energy Saving; Auto Switch Off; Cleaning & Maintenance; Descaling Process - Di4 Jet Pressing Healthy 8b Manual De Instrucciones

Vertical steam
Can be used to remove creases from hanging clothes, curtains, etc.
1. Choose the "max" setting by turning the selector (1).
2. Hold the iron in an upright position 15 cm away from the garment to be steamed.
3. Press the steam release button (15) repeatedly with pauses of at least 5 seconds.
Warning!: never point the steam jet at garments being worn, or at people or animals.

5. Energy saving

If the energy saving setting is selected, you can save energy and water and still achieve good results
when ironing most of your garments.
1. Press the energy saving button "Eco" (5). The indicator light will come on.
2. To switch back to the normal energy setting, press the "Eco" button again. It is advisable to use the
normal energy setting to get optimum results on thick and very wrinkled fabrics.
Tips to help you save energy:
• If you tumble dry your fabrics before ironing them, set the tumble drier on the iron dry programme.
• Try to iron the fabrics while they are still damp and reduce the steam setting. Steam will be generated
from the fabrics rather than the iron.

6. Auto switch off

For your safety and to save energy, the appliance switches off automatically when it has not been used
for 8 minutes.
Three beeps will be heard, and all indicator lights (2,3,4,5) will flash.
1. To switch the steam station back on, press the steam release button (15) again.
CLEANING & MAINTENANCE

1. Descaling process

Important: to keep your appliance in good condition for a long time, you should carry out the
descaling process after a period of use. The "Calc'nClean" indicator light (3) will flash and three
beeps will be heard, indicating that the process should be performed. You may continue ironing,
but before the next use, while the appliance is cold, a descaling process should be performed.
Descaling the boiler
1. Take special care to ensure that the appliance is cold and unplugged.
2. Empty the water tank.
3. Remove the iron from the pad (13).
4. Unscrew and remove the boiler cap (9) and take it out. Empty the boiler completely.
5. Fill the boiler with approximately 300 ml of tap water. Close the boiler cap and shake the base unit
for a few moments. Then, empty it completely.
Important: To obtain the best result, we recommend that this operation be performed twice. Before
re-closing, make sure no water remains in the boiler.
6. 8If your appliance is equipped with scale collector (9*), it must be washed (see the "Descaling the
scale collector" section).
7. Replace and tighten up the cap.
Descaling the limescale collector *
1. Place the limescale collector (9*) under the water tap.
2. Wash it up until limescale residues are removed.
EN
23