Di4 Jet Pressing Healthy 8b Manual De Instrucciones página 25

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Trouble shooting
Problem
The iron begins to
smoke when switched
on.
Water flows through the
holes on the soleplate.
Dirt comes out through
the soleplate.
The "Calc'nClean"
indicator light (3) does
not turn off.
The ironed garment
turns a dark colour
and/or sticks to the
soleplate.
The appliance makes a
pumping sound.
Loss of pressure during
ironing.
Water spots appear
on the garment during
ironing.
The hose gets hot
during use. The hose
gets hot during use.
Water leakage from the
boiler.
The "Water tank empty"
indicator light (4) comes
on.
If the above tips do not solve the problem, get in touch with our customer service.
Possible causes
1. During first use: certain components
on the appliance have been lightly
greased at the factory and may produce
a small amount of smoke when initially
heated.
2. During subsequent use: the soleplate
may be soiled.
1. The water is condensing inside the
tubes because steam is being used for
the first time or has not been used for a
long time.
1. There is a build up of limescale or
minerals in the boiler and iron.
2. Chemical products or additives have
been used.
1. The iron descaling process has been
stopped before being completed.
1. The selected temperature is too high
and has damaged the garment.
1. Water is being pumped into the steam
tank.
2. The sound does not stop.
1. The steam release button has been
activated for too long a period of time,
meaning it has been pressed too
frequently.
1. May be caused by steam condensed
on the ironing board.
1. This is normal. It is caused by the
steam passing through the hose during
steam ironing.
1. Boiler cap (9) is loose.
1. The water tank is empty or not
correctly fitted onto the appliance.
Solution
1. This is completely normal and will
stop after a short while.
2. Clean the soleplate according to the
cleaning instructions in this manual.
1. Point the iron away from the ironing
area and press the steam release
button until steam is produced.
1. Carry out a cleaning cycle (see the
"Descaling process" section).
2. Never add products to the water
(see the "Filling the water tank"
section).
Clean the soleplate with a damp cloth.
1. Restart and complete the iron
descaling process.
1. Select a suitable temperature for
the material being ironed and clean
the soleplate with a damp cloth.
1. This is normal.
2. If the sound does not stop, do not
use the steam station and contact an
authorised technical service centre.
1. Use the steam release button at
intervals.
1. Wipe the textile cover of the ironing
board, and iron any water drops to
dry them.
1. Place the hose on the opposite
side so that you do not touch the hose
during ironing.
1. Tighten the cap.
1. Fill the water tank or fit it correctly.
EN
25

Publicidad

Tabla de contenido
loading

Tabla de contenido