EdilKamin CALGARY Instalación Uso Y Mantenimiento página 29

shapes of pressed wood whose combustion is controlled elec-
tronically.
The fuel tank (A) is located at the rear of the boiler. Filling the
tank is through the back of the lid at the rear of the top.
gear motor it is then transported to the combustion crucible (D).
The ignition of the pellet is via air heated by an electrical he-
ating element (E) and is sucked into the crucible by a smoke
extractor (F)
The combustion air is drawn into the room (where there must
be an air intake) smoke extractor (F).
from the pipe union (G) located in the bottom portion of the
rear of the boiler.
The ash falls under and beside the crucible in which is housed
an ash (H) tray from which the ash must be periodically remo-
ved by vacuuming when cool.
The entire boiler and door are insulated which makes it more
not dissipated in the place of installation but is conveyed only
to the hydraulic system.
The boiler is designed to function with closed expansion tank
A hydraulic kit (P) is located on the boiler which consists of:
tank
The inclusion of the anti-condensation thermostatic valve
prevents corrosion that would otherwise compromise the life of
the boiler body.
pump activation are regulated by the control board which is
equipped with Leonardo software to achieve high combustion
®
bipolar socket for connection to an external graphics panel and/
or to Domoklima.
The synoptic panel (L) which allows managing and viewing all
A serial port is found at the back of the boliler (optional cable:
code 640560) to be connected to devices that allow remote
Operating modes
The temperature of the water required in the system is set via
manually or automatically modulates the power to maintain or
reach this temperature.
The Eco function can be enabled in small systems (the boiler
shuts down and goes on again according to the water tempera-
ture required).
FEATURES
In addition it is equipped with a
I
L
N
-
M
O
D
H
pellet hopper
A
pellet feed screw
B
feed screw gear motor
C
combustion chamber
D
ignition electrical resistance
E
centrifugal fan
F
smoke outlet Ø 100 mm
G
ash pan
H
closed expansion tank
I
synoptic panel
L
insulated external door
M
inspection door for cleaning
N
O peep-hole with safety functions
Hydraulic kits
P
Innovative ceramic combustor with catalyst unitwhich in-
type of pellets used and the hydraulic system).
- 29
-
A
B
F
E
C
P
limiting
(depending on the
G