Chimney Pot - EdilKamin CALGARY Instalación Uso Y Mantenimiento

INSTALLATION
(must be carried out by an authori-
sed service centre, CAT, or by personnel authorised to issue
Refer to local regulations in the country of use for anything
Health Authority regulations.
the block administration before installing.
VERIFY COMPATIBILITY WITH OTHER
DEVICES
The boiler must NOT be installed in the same room as extrac-
affect its operation.
VERIFYTHE POWER SUPPLY
CONNECTION
(the plug must be accessible)
The boiler is supplied with a power cable that is to be con-
gnetothermic switch. Voltage variations exceeding 10% can
The electrical system must comply with the law; particularly
The power line must have a suitable cross-section for the boiler
power.
An inadequate earthing system can cause anomalies for which
Edilkamin cannot be held liable.
FIRE SAFETY DISTANCES AND LOCATION
For correct operation the boiler must be level.
be installed in compliance with the following safety conditions:
- minimum safety distance at the sides and back from medium
cm from the front of the boiler.
insulating material must be placed between the boiler and the
at the front.
Flammable objects must not be placed above the boiler or at a
distance that is any less than the stipulated safety distances.
the smoke exhaust pipe must be appropriately insulated with
AIR INLET: to be mandatorily implemented.
The room where the boiler is placed must have an air inlet with
air supply to the boiler for combustion.
INSTALLATION
SMOKE OUTLET
The boiler must have its own smoke outlet (the smoke cannot
The smoke is discharged through the 10 cm diameter outlet at
the back of the boiler.
A T-junction must be set up with a condensation collection
stopper at the beginning of the vertical section.
The smoke outlet must be connected to outside by means of
The pipe must be hermetically sealed. The material used to seal
temperatures (high temperature silicone or mastic).
The only horizontal section allowed may be up to 2 m long.
The vertical duct can be internal or external.
If the smoke channel (part of the pipe that goes from the boiler
-
ted.
must be suitable for solid fuel.
If it is wider than 150 mm in diameter it must be improved by
entering a pipe that has a suitable cross-section and is made of
suitable material (e.g. 100 mm diameter steel).
All sections of the smoke duct must be accessible for inspec-
tion.
cleaning.
TYPICAL EXAMPLES
Fig. 1
A:
B:
C-E: air intake from outside (through section at least 80 cm²)
D:

CHIMNEY POT

The main characteristics are:
- an outlet cross-section which is no smaller than twice that of
- its position must be high enough to catch the wind and avoid
downdraft areas in turbulent wind..
- 31
-
-
Fig. 2