Preparation - EUFY RoboVac L35 Hybrid+ Manual Del Usuario

Remove power cords and small objects from the floor that may entangle RoboVac.
Fold tasseled edges of rugs underneath to prevent tangling RoboVac. Avoid
cleaning dark-colored high-pile rugs or rugs thicker than 1.02 in / 26 mm as they
may cause RoboVac to malfunction.
It is strongly recommended to set a No-Go zone or a virtual boundary in the
EufyHome app in front of fireplaces and certain areas (i.e. air vents) that may
cause damage to RoboVac if entered.
Keep RoboVac away from wet areas during cleaning.
RoboVac may climb on top of objects less than 0.79 in / 20 mm in height.
Remove these objects if possible.
Anti-drop sensors will prevent RoboVac from tumbling down stairs and steep
drops in most cases. Sensors are less effective if dirty or used on carpeted /
reflective / dark-colored floors. It is recommended to place physical barriers or set
a No-Go zone / a virtual boundary in the EufyHome app to block off areas where
RoboVac may fall.

Preparation

1
Remove the foam blocks beside the bumper before use.
2 Before mopping, install the waterproof pad under the auto empty station to
keep the floor dry. Make sure it is firmly installed. Skip this step if mopping is not
needed.
16 EN
3
Place the auto empty station on a level surface and against a wall.
4
Remove objects within 1.6 ft / 0.5 m of the left and right side and within 4.9 ft /
1.5 m of the front of the auto empty station. If you cannot remove the objects,
check whether RoboVac can return to the auto empty station normally. If not,
contact eufy customer service for help.
EN 17