Using Your Robovac; Important Tips Before Use; Preparation - EUFY RoboVac G20 Hybrid Manual Del Usuario

Using Your RoboVac

Important Tips Before Use

A B
D E
Remove power cords and small objects from the floor that may entangle RoboVac.
Use the supplied cable ties to organize your wires and power cords.
Fold tasseled edges of area rugs underneath to prevent tangling RoboVac. Avoid
cleaning very dark-colored high-pile rugs or rugs thicker than 1.02 in/26 mm as
they may cause RoboVac to malfunction.
It is strongly recommended to place boundary strips (sold separately) in front of
fireplaces and certain areas (i.e. air vents) that may cause damage to RoboVac if
entered.
Keep RoboVac away from wet areas during cleaning.
RoboVac may climb on top of objects less than 0.67 in/17 mm in height. Remove
these objects if possible.
Anti-drop sensors will prevent RoboVac from tumbling downstairs and steep drops
in most cases. Sensors are less effective if dirty or used on carpeted/reflective/very
dark-colored floors. It is recommended to place physical barriers to block off areas
where RoboVac may fall.
12 EN
C
F

Preparation

1
Remove the foam blocks beside the bumper before use.
2
Install the side brush before use.
3
Before mopping, attach the waterproof pad to the Charging Base to keep the floor
dry. Make sure it is firmly installed. Skip this step if mopping is not needed.
4
Turn on the main power switch on the bottom of RoboVac.
OFF
ON
EN 13