VALBERG CIH 60 EGK 302C Instrucciones De Uso página 12

C
Useful information
Installation of grease filters
• To install the filters, please follow the following four steps.
- Tilt the filter in the slots at the rear of the hood.
- Push the button on the handle of the filter.
- Release the handle once the filter is locked in position.
- Repeat to install all the filters.
Charcoal filter (not supplied)
An activated charcoal filter may be used to neutralise odours.
Normally, the charcoal filter should be changed every three
to six months, depending on cooking habits. The installation
procedure of the activated charcoal filter is as follows:
Recycling version:
To transform the hood from the evacuation version to the
recycling version, ask your dealer for activated charcoal
filters.
Installing the activated charcoal filter (cassette)
• The aluminium filter must be removed to install the
activated charcoal filter.
20 EN
C
Useful information
• Open the grating, press the locking device and pull the
filter downwards.
• Place the activated charcoal filter inside the appliance and
fasten it by turning anticlockwise.
• Replace the grating in its original position.
Installing the activated charcoal filter (cut-out)
• The aluminium filter must be removed to install the
activated charcoal filter.
• Place the precut filter above the aluminium filter.
• Replace the aluminium filter.
• We recommend running the hood for a few minutes before
starting to cook. We also recommend switching it off 15
minutes after cooking has finished to eliminate odours as
much as possible and remove bad air.
21 EN