Useful Information - VALBERG CIH 60 EGK 302C Instrucciones De Uso

C

Useful information

IMPORTANT:
• The bulb must be replaced by the manufacturer, one of
its technicians or a qualified person.
• Always switch off the power before performing any
operation on it. Before handling the bulb, make sure it
has completely cooled.
• When handling bulbs, hold them with a cloth or gloves
to ensure that sweat does not come into contact with
them, as this may reduce their life
Replacement the lamp
Light source in this product can only be replaced by qualified professionals.
Please contact after-sales service if the light source fails. The light source shall be removed
at the end of the product's useful life, with sorting and recycling done separately.
• The ILCOS D code for this lamp is: DSR-1.5/65-S-64
- LED modules - round bulb
- Max power : 2 x 1.5 W
- Voltage range: 12V DC
- Dimensions: Φ64mm
24 EN
C
Useful information
Troubleshooting
Problem Potential causes
The fan switch is disabled.
The light comes on but the
The fan is out of order
motor is not working.
The motor is out of order.
The home's fuses are
The light comes on but the defective.
motor is not working. The power cord is detached
or disconnected.
The check valve and the
output device have a sealing
defect.
Oil leak
There is a leak on the
connection between the duct
and its cover.
The bulbs are defective/
The light is not working.
broken.
The distance between the
Insufficient suction hood and the stove is too
large.
The mounting screws are not
The extractor hood is tilted.
tight enough.
COMMENT : All electrical repairs to this appliance must comply
with your local, state and federal legislation. If in doubt, contact
the service centre before undertaking anything. Always unplug
the appliance from the power source if you need to open it.
25
Solution
Select a position for the fan switch.
Contact the service centre.
Contact the service centre.
Reset / Replace fuses.
Re-plug the cord into the power socket.
Switch on the power socket.
Dismantle the check valve and seal it
using a sealant.
Remove the duct and seal the leak.
Replace the bulbs in accordance with
this manual.
Reposition the hood at the right
distance.
Tighten the suspension screw by
aligning the hood horizontally.
EN