Using The Appliance - VALBERG CIH 60 EGK 302C Instrucciones De Uso

Ocultar thumbs Ver también para CIH 60 EGK 302C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

B

Using the appliance

Installation (external outlet)
Before using the appliance for the first time, please consider the following tips.
Mounting the check valve
If the extractor hood is not equipped with an assembled check valve
halves onto the body of the hood. The illustrations for mounting the check valve are provided
below as an indication. The evacuation may vary depending on the model and configuration.
1
To mount the check valve
:
6
2
• Fit the two halves
into the housing
;
3
• Direct the stem
upwards;
5
4
• Insert the axis
into the holes in the
housing;
• Repeat all the operations for the other half.
Installation
If you have an external evacuation, you can connect your extractor hood as illustrated below
using an extraction duct (flexible tube made from aluminium, enamel or other non-flammable
material tube with an internal diameter of 150 mm).
1. Switch off the appliance and disconnect from the mains prior to installation.
2. For optimum results, the extractor hood should be installed at a distance of 65 to 75 cm
above the cooking surface.
12
1
, you must mount the two
EN
B
Using the appliance
3. After deciding on the height of the extractor hood, measure the position of the holes required
to suspend the hood as well as the inner duct mount. Drill 4 holes of 8: 2 for the inner duct
mount and 2 others to suspend the hood, while making sure it is properly levelled. The position
of the inner duct mount corresponds to the location of the duct. See figure 2
4. Screw two 4 x 30 mm screws to the wall using dowels to secure the hood, then use two 4 mm
x 40 mm screws to secure inner duct mount. See figure 2
5. Install the transformer as well as the expansion pipe on the outlet. Attach the extension pipe
to the transformer using the clamp. See figure 3
Reminder: the extension pipe is not supplied.
extension pipe
5. Install the outer duct mount using 2 ST4*8mm screws, ensuring that the inner duct remains
flexible. See figure 4
13
75 cm
65 cm
Figure 2
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cih 90 egk 302c970127970128

Tabla de contenido