VALBERG CIH 60 EGK 302C Instrucciones De Uso página 9

B
Using the appliance
inner duct
outer duct mount
outer duct
6. Suspend the hood from the wall by adjusting its position and fix the extractor hood using 2
ST4*30 mm safety screws.
COMMENT :
The two safety vents are placed on the rear cover and have a 6 mm
diameter. See figure 5
7. Adjust the height of the inner duct relative to the position of the inner duct mount and fix
it all using 2 ST4*8 mm screws. See figure 6
14
Figure 4
Figure 5
Figure 6
EN
B
Using the appliance
Recommendations for installation of the evacuation duct
The following rules must be strictly followed, in order to obtain optimal air extraction:
• Keep the evacuation duct short and straight.
• Do not shorten or obstruct the evacuation duct.
• If you use a flexible pipe, always install it so that it is properly stretched out to limit pressure losses.
• Failure to comply with these basic instructions will reduce the performance of the hood and
increase its noise level.
• All installation work must be carried out by a qualified electrician or a competent person.
• Do not connect all the ducts in the hood to an existing ventilation system that is used for another
device, such as heating, gas or hot air ducts. The angle of curvature of the ventilation duct shall not
be less than 120º; you need to position the duct horizontally. Otherwise, raise the pipe vertically
from the entry point and guide it towards an outside wall.
• Once the installation is complete, check that the extractor hood is level to avoid any accumulation
of grease on one end.
Ensure that the evacuation duct chosen for the installation meets applicable standards and is
flame retardant.
Correct
WARNING :
For safety reasons, please only use fastening or mounting screws with
the dimensions recommended in this user manual. Any non-compliant installation of the
screws or fastening devices with these instructions presents an electrical hazard.
15
Incorrect
EN