Bauknecht HIS3 EP8V2 IN Guía Rápida página 14

ACCESSORIES
WIRE SHELF
The number and the type of accessories may vary depending on which model is purchased.
Other accessories that are not supplied can be purchased separately from the After-sales Service.
INSERTING THE WIRE SHELF AND OTHER
ACCESSORIES
Insert the wire shelf horizontally by sliding it across
the shelf guides, making sure that the side with the
raised edge is facing upwards
Other accessories, such as the drip tray and the
baking tray, are inserted horizontally in the same way
as the wire shelf.
FITTING THE SLIDING RUNNERS
(ONLY IN SOME MODELS)
Please note: The sliding runners can be already mounted on
the shelf guides: to remove them, pull outward, releasing first
the lower clip.
Remove the shelf guides from the oven and remove
the protective plastic from the sliding runners.
To secure the guide, press
the lower portion of the
clip firmly against the
shelf
guide. Make sure that the
runners can move freely.
Repeat these steps on the
other shelf guide on the
same level.
Please note: The sliding runners can be fitted on any level.
DRIP TRAY
Fasten the upper clip of the
runner to the shelf guide
and slide it along as far as it
will go. Lower the other clip
into position.
WWW
BAKING TRAY
REMOVING AND REFITTING THE SHELF GUIDES
. To remove the shelf guides, remove the fixing
screws (if present) on both sides with the aid of a
coin or a tool. Lift the guides up and pull the lower
parts out of their seatings: The shelf guides can now
be removed.
. To refit the shelf guides, first fit them back into
their upper seating. Keeping them held up, slide them
into the cooking compartment, then lower them into
position in the lower seating. Refit the fixing screws.
Download the Use and Care Guide from
docs. bauknecht. eu for more information
SLIDING RUNNERS
(IF PRESENT)