12
www.aeg.com
The information given in the chart above are in compliance with the EU Commission regu-
lation 1015/2010 implementing directive 2009/125/EC.
7. OPTIONS
7.1 Temp.
When you set a programme, the
appliance automatically proposes a
default temperature.
Press this button repeatedly until the
temperature value you want appears on
the display. The graphic bars fill
accordingly your selection.
When the display shows
graphic bars are empty, the appliance
does not heat the water.
7.2 Centrif.
When you set a programme, the
appliance automatically proposes the
maximum spin speed provided for that
programme.
Press this button repeatedly to set the
speed value or to select one of the
available options. The corresponding
indicators appear on the display.
The graphic bars fill accordingly your
selection.
• RINSE HOLD
If you select this option, the water of
the last rinse is not emptied out to
prevent the fabrics from creasing. At
the end of the programme, the
corresponding indicator is on in the
display and the door remains locked.
The water must be emptied out
before opening the door.
• NIGHT CYCLE
If you select this option, the appliance
does not drain the water and all
spinning phases are suppressed. In
this way the laundry is not wrinkled.
As the programme is very noiseless, it
can be set in the cheapest power rate
hours.
Off Mode (W)
0,10
and the
Left On Mode (W)
0,98
In some programmes the rinses are
performed with more water. At the
end of the programme, the
corresponding indicator is on in the
display and the door remains locked.
To empty out the water, please read
chapter 'End of programme'.
7.3 Fun./Funç.
With this button you can see and scroll
on the display the following options (they
are available according to the
programme selected):
Prelava.
Use this option to add a prewash phase
at 30°C to a programme.
The prewash ends with a short spin in
programmes for cottons and synthetics,
whereas in the programmes for delicates
the water is only drained. This option is
recommended for heavily soiled laundry.
The set of this option
increases the programme
duration.
Manchas/Nódoas
Set this option to add a stain phase to a
programme to treat heavily soiled or
stained laundry with stain remover.
This option increases the programme
duration.
This option is not available
with a temperature lower
than 40° C.
Put the stain remover into compartment
.