Metabo HPT NT 1850DF Instrucciones Y Manual De Seguridad página 18

English
(4) Remaining battery level
While power switch ON, the battery remaining level
can be checked by status of LED lamp as below.
Status of indicator
LED do not light
LED (Red) blinks
LED (Red) lights
(5) Other functions
In case of operation error, LED lamps show as below.
Status of indicator
LED (Red) blinks
LED light
LED light blinks in an
interval.
• In case of too hot
condition, blinks in
1 second interval.
• In case of too cold
condition, blinks in
0.5 second interval.
After 10 seconds,
automatically turns off LED
light and Power switch.
LED (Orange) blinks
18
The battery remaining
power is enough.
The battery remaining
power is nearly empty.
The battery remaining
power is empty.
Recharge the battery as
soon as possible.
Machine is in too cold
(below 23°F (-5°C) or too
hot condition.
Allow the nailer to cool
or warm-up thoroughly in
adequate condition.
Error is occurred.
Once remove the battery.
Then attach the battery
and power ON again.
LED (Orange) lights
(6) How to use the LED light
While the power switch on, the LED light will
automatically light up the tip portion of the tool.
CAUTION
● Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
● Wipe off any dirt or grime attached to the lens of
the LED light with a soft cloth, being careful not
to scratch the lens.
Scratches on the lens of the LED light can result
in decreased brightness.
(7) Remaining battery indicator
You can check the battery's remaining capacity by
pressing the remaining battery indicator switch to
light the indicator lamp. (Table 5)
The indicator will shut off approximately 3 seconds
after the remaining battery indicator switch is
pressed.
It is best to use the remaining battery indicator as
a guide since there are slight diff erences such as
ambient temperature and the condition of the battery.
Also, the remaining battery indicator may vary from
those equipped to a tool or charger.
Contact metabo HPT for
inspection.
Light in green