Metabo HPT NT 1850DF Instrucciones Y Manual De Seguridad página 24

English
Remove fi nger from the trigger and lift the tool off
the wood surface completely.
To continue nailing in a separate location, move the
nailer along the wood, repeating steps
required.
NOTE
Operations and
4 seconds of each other. If more than 4 seconds
pass after the Nailer will not work properly. If this
happens, retry from
Nailing
operation
switch
Push lever
● A nail will fi re each time the trigger is
depressed as long as the push lever remains
depressed.
(2) Continuous operation (Push lever fi re)
Using CONTACT ACTUATION MECHANISM
● To avoid double fi ring or accidental fi ring due
to recoil.
1) Do not press the nailer against the wood
with excessive force.
2) Separate the nailer from the wood as it
recoils after nailing.
Set the nailing operation switch to CONTACT
ACTUATION MECHANISM
indicator is blink in blue.)
Pull the trigger with the Nailer off the workpiece.
Depress the push lever against the workpiece to drive
a nail.
24
should be done within
.
Nailing
operation
indicator
(Light in
blue)
Trigger
WARNING
WARNING
(Nailing operation
Move the Nailer along the workpiece with a bouncing
motion.
Each depression of the push lever will drive a nail.
– as As soon as the desired number of nails have been driven,
remove fi nger from the trigger.
NOTE
Operations
2 seconds of each other. If more than 2 seconds
pass after
happens, retry from
Nailing
operation
switch
Push lever
● Keep your fi nger off the trigger except during
nailing operation, because serious injury
could result if the push lever accidentally
contacts you or others in work area.
● Keep hands and body away from the
discharge area. This metabo HPT nailer may
bounce from the recoil of driving a nail and
unwanted subsequent nail may be driven,
possibly causing injury.
NOTE
● If all warnings and instructions are followed,
safe operation is possible with all two systems:
SINGLE SEQUENTIAL ACTUATION MECHANISM,
CONTACT ACTUATION MECHANISM.
● Always handle nails and package carefully. If nails
are dropped, collating bond may be broken, which
will cause mis-feeding and jamming.
● After nailing:
1) remove battery from the Nailer;
2) remove all nails from the Nailer;
and should be done within
, the Nailer will not work properly. If this
.
Nailing
operation
indicator
(Blink in
blue)
WARNING
Trigger