Using The Nose Cap; Clearing A Jam - Metabo HPT NT 1850DF Instrucciones Y Manual De Seguridad

English

USING THE NOSE CAP

● When attaching or detaching the nose cap,
be sure to remove your fi nger from the trigger
and remove all remaining fasteners and the
battery from the nailer.
If you like to protect the surface of workpiece against
scratches or markings made by the push lever, attach the
accessory nose cap to the push lever.
Remove all remaining fasteners and battery from
nailer.
Put the nose cap to the toe of the push lever.
When not using the nose cap, secure in the storage
compartment located on the reverse side of the
magazine.
Nose Cap
NOTE
● The nose cap may reduce nailing depth due to its
thickness. Re-adjustment of nailing depth is required.
26
WARNING
Push Lever
Nose Cap
Magazine

CLEARING A JAM

If nails are jammed in fi ring head, remove it, and adjust the
nailing in the following order.
CAUTION
● Remove the battery from the Nailer.
Remove the battery from the Nailer.
Remove all nails.
Release the Lock lever and open guide plate.
Lock lever
Remove the jammed nail with a slotted-head
screwdriver.
CAUTION
● NEVER hit the driver blade.
● NEVER point the tool at yourself or another
person, to avoid risk of injury by mis-fi ring.
Even if the battery is removed from the nailer,
there is still energy of compressed air remaining
inside.
Close guide plate and latch.
NOTE
● In case of frequent jam, contact a metabo HPT
authorized service center.
Guide Plate