KTM 61912922044 Instrucciones De Montaje página 34

7 OPTIONAL
7.1
14
Locking cylinder for the cover lock
502164-01
502165-01
500517-01
500518-01
502173-01
Installing the locking cylinder
–
bk
Insert springs (included) into chambers
E
.
Tip
The kit contains many small parts. It is recommen-
ded that you perform the assembly while seated at
a table.
–
9 (included) with the number 1 into cham-
Insert wafers
A C E
bers , , and
–
Insert the key and check whether the tumblers with the
number 1 are correct.
All tumblers close flush with the locking cylinder.
–
Replace the non-matching tumblers with ones that have
the matching number.
Tip
It is recommended that you note the numbers of
the matching tumblers so that the subsequent
locking cylinders can be equipped immediately.
–
Repeat the steps for chambers
first six chambers are fitted with the correct wafers.
–
Insert the key.
All tumblers close flush with the locking cylinder.
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert locking cylinder as shown.
The engaging plate
bl
Engaging plate
–
Pull up the locking device.
–
6
Position hook lock
as shown.
A C
,
.
B D F
, , and until the
3
(included).
p. 16)
bl
points to the right.
engages.
(included) on the locking cylinder
, and