Emos P5604 Manual De Instrucciones página 5

a. HEAT (heating system)
b. OFF (anti-freeze temperature of 7 °C)
c. COOL (cooling system)
3. Press the control wheel to confirm your selection.
Room Temperature Calibration
Press and hold the control wheel for 5 seconds until the setting mode
indicator starts flashing on the screen.
Press and hold the control wheel again for 5 seconds until the temperature
calibration value starts flashing on the screen.
Use the wheel to set the temperature value of choice (-3.0 °C to 3.0 °C,
in 0.5 °C steps) and confirm by pressing the wheel.
Room temperature calibration is used if, for example, the thermostat
shows 21 °C but you want it to show 20 °C. In that case, the calibration
value should be set to -1 °C.
Upkeep and Maintenance
The product is designed to provide trouble-free service for many years if
used properly. Here are some tips for proper operation:
• Read the manual carefully before using this product.
• Do not expose the product to direct sunlight, extreme cold and
humidity, and sudden changes in temperature. This would reduce
accuracy of detection.
• Do not place the product in locations prone to vibration and shocks
– these may cause damage.
• Do not expose the product to excessive force, impacts, dust, high
temperatures or humidity – these may cause malfunction, shorter
battery life, damage to batteries and deformation of plastic parts.
• Do not expose the product to rain or high humidity, dropping or
splashing water.
• Do not place any open flame sources on the product, e.g. a lit
candle, etc.
• Do not place the product to places with inadequate air flow.
• Do not insert any objects in the product vents.
• Do not tamper with the internal electric circuits of the product – doing
so may damage the product and will automatically void the warranty.
The product should only be repaired by a qualified professional.
• To clean the product, use a slightly moistened soft cloth. Do not use
solvents or cleaning agents – they could scratch the plastic parts
and cause corrosion of the electric circuits.
• Do not immerse the product in water or other liquids.
• In the event of damage or defect of the product, do not perform any
repairs by yourself. Have it repaired in the shop where you bought it.
5