Operator Presence Control (Opc); Pto (Power Take-Off) Button; Forward And Rearward Pedals; Auxiliary Power Switch (Aux) - Husqvarna P 535HX Manual De Usuario

Operator presence control (OPC)

The OPC is engaged when the operator lifts from the
seat. The OPC indicator in the display comes on. The
OPC engages the safety circuit. Refer to
on page 22 .

PTO (Power Take-Off) button

The PTO button engages and disengages the PTO
clutch and the cutting deck or other equipment
connected to it. The correct start conditions must be
obeyed to engage the drive of the blades. Refer to
Safety circuit on page 22 for the correct start
conditions.
• Pull the PTO button out to engage the drive to the
blades or other equipment.
• Push the PTO button in to disengage the drive to the
blades or other equipment.
PTO speed switch
The PTO speed switch can be set in 3 positions for
operation with different types of cutting decks or other
equipment. When the PTO button is engaged, the
engine speed is supplied to the cutting deck or other
equipment that is attached to the PTO shaft. Refer to
set the PTO speed on page 36 and Technical data on
page 64 .
Note:
For operation with cutting decks, use the high
PTO speed.

Forward and rearward pedals

The speed is gradually adjusted with 2 pedals. The left
pedal (A) is used to move forward, and the right pedal
1591 - 001 - 21.12.2020
(B) is used to move rearward. The product brakes when
the pedals are released.
Safety circuit
Lever for the hydraulic lifting arms
The lever for the hydraulic lifting arms is used to lift and
lower the cutting deck and other equipment.
•
•
To
•
•

Auxiliary power switch (AUX)

The auxiliary power switch has different functions for
different cutting decks and for other equipment. Refer to
A
C
B
A
WARNING:
hydraulic lifting arms after you stopped the
product. Make sure to stop the product
where the cutting deck or other equipment
can be lowered safely.
(A) Float position (mow position), the cutting deck or
other equipment follows the ground independently of
the product.
(B) To lower the cutting deck or other equipment.
(C) Neutral position.
(D) To lift the cutting deck or other equipment.
B
D
It is possible to lower the
9