Sauder Englewood 426918 Manual De Instrucciones página 16

Step 10
å
Separate the EXTENSION SLIDES (40MC) from the EXTENSION RAILS (40MA) as shown in the upper
diagram below. Be prepared, the parts are greasy.
å
Fasten one EXTENSION RAIL (40MA) to the RIGHT UPRIGHT (D). Use two GOLD 5/16" FLAT HEAD
SCREWS (3S) through holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then,
slide the inner cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in
the UPRIGHT. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the FILE DRAWER.
40MC
Push the black lever in and pull the SLIDE from the RAIL.
Page 16
4
3
D
426918
40MA
GOLD 5/16" FLAT HEAD SCREW
(2 used in this step)
2
1
www.sauder.com/service
7
3S
Open end